1. Embedded pipeline. When wiring lawn lamps, a wire smaller than the distribution phase line shall be used as the grounding wire to connect the metal shell of lamps or lamp posts, and the grounding wire shall be connected to the "ground" of the system. If the length of the grounding wire is more than 25 meters, the end shall be repeatedly grounded. A 4mmx40mm galvanized flat iron with a length of 25 meters can be buried for repeated grounding, and five grounding electrodes shall be applied × 50 galvanized angle steel, 5m long, is vertically driven into the ground, and the grounding electrode and galvanized flat iron are welded at a distance.
2. Foundation pouring. The foundation pouring of lawn lamps is usually done by the construction workers in the early stage, but it should be noted that the embedded pipelines need to be led out to avoid the failure of normal use in the later stage
3. Install the lawn lamp. Open the package of lawn lamp and check its integrity. Assemble the lamp according to the product manual The general practice is to open the lamp housing, install the light source and supporting electrical appliances, lead the outgoing line from the threading hole to the bottom of the lamp pole, then connect the lamp cap with the lamp pole, tighten the fastening screws, and then align the lawn lamp flange with the embedded screw of the foundation, standing vertically. Then, tighten the mounting nuts after leveling with nuts or pads
4. Power cord wiring. The connection of lawn lamps should be carried out by professional electricians. At the same time, safe and reliable grounding must be done to avoid leaving potential risk factors for later use
